19th Ave New York, NY 95822, USA

serv-Clip Tip 1

serv-Clip Type 1

Pipe measuring point serv-Clip® Type 1 (for mounting on pressurized pipes)

 

 

Pipe measuring point serv-Clip® Type 1 (for mounting on pressurized pipes) with 1/4" screw
For hydraulic and gear oils
Installation of Sensors in few minutes – no cutting pipelines – Installation with jaw/screw wrench only

hydraulik-measuring-coupling-servclip1

How it works?
A needle is pressed through the wall of the pipe. It uses the principle of plastic deformation to create a leak-proof opening.

 

tube-measuring-point-servclip1_mounting

tube-measuring-connection-servclip

Hydraulic pipe measuring point serv-Clip® Type 1 (for mounting on pressurized pipes)

This is what you can do instantaneously:
Measure pressure
Take oil samples
Bleed lines / Install pressure gauges
Install pressure sensors or pressure switches
Carry out particle measurements according to ISO or NAS-classes
Install flow filters

Why?
Quick and cheap installation (only 3 minutes)
Measurement without switching off
No need to cut tubes
No cleaning necessary
No contamination of fluids

Technical data

  • For installation on steel and (*)stainless steel pipes

  • For diameters:
    from 10 – 42 mm /Tube 3/8" –  2" / Pipe ¼" to 3"

  • Working pressure up to 630 bar (9100 psi)

  • Working temperature from -40°C to +120 °C

  • Viton O-Ring in leak proof clamp (200°C) incl 1/4"screw and valve M16x2

(*)Up to 5 mm with special needle Art.Nr.501-040-02 possible.