serv-Clip Type 2
Pipe measuring point serv-Clip® Type 2 (for mounting on non-pressurized pipes)
Pipe measuring point serv-Clip® Type 2 (for mounting on non-pressurized pipes) with 3/8"screw
For hydraulic and gear oils
Installation of Sensors in few minutes – no cutting pipelines – Installation with jaw/screw wrench only
How it works?
A needle is pressed through the wall of the pipe. It uses the principle of plastic deformation to create a leak-proof opening. Finally you remove the needle and stirrup to measure.
Hydraulic pipe measuring point serv-Clip® Type 1 (for mounting on pressurized pipes)
This is what you can do instantaneously:
Take oil samples
Bleed lines / Install pressure gauges
Install pressure sensors or pressure switches
Carry out particle measurements according to ISO or NAS-classes
Install flow filters
Installation from fluid-Check® Sensors and other with G 3/8":
fluid-Check Flow rate
Aqua (in 2012 new!)
Quick and cheap installation (only 3 minutes)
No need to cut tubes
No cleaning necessary
No competition in the market!
For installation on steel and (*)stainless steel pipelines
from 10 – 42 mm/ Tube 3/8"- 2"/ Pipe ¼" to 3"
Working pressure up to 630 bar (9100 psi)
Working temperature from -40°C to +120 °C
Viton O-Ring in leak proof clamp (200°C)
Incl 3/8" screw and valve M16x2
(*) Up to 5 mm with special needle Art. Nr. 501-041-02 possible.